New bench

[nueces5]

After a couple of years since I started, I set about putting together a new casting place.
I put a couple of metal plates, on the wood of the table where the oven rests reads
The temperature gauge comes from above, and I fixed the temperature gauge held on the shelf above
we'll see how it works

[lightman]

Sounds good. But I can't see the picture, just a little blue box with a ? mark.

[Mike W1]

Worked fine on my laptop.

[nueces5]

[kevin c]

Nice! The metal surface lets you set down the mold and other hot items anywhere.

Where I cast I need to be able to stow the gear away, leaving just the wooden bench top. I put the pots over a lipped baking sheet or, now that I have stacked pots (feeder over bottom pour) an automotive drip pan. In the unlikely event of a tip over or valve failure, all the lead except what might splash out is contained.