Looking for suggestions for a bullet mold for my 510 Whisper -- Something 650-750g.
Looking for suggestions for a bullet mold for my 510 Whisper -- Something 650-750g.
Accurate Molds and if the stock designs don’t move you you can design your own. MP molds has a great 525 grain solid and it drops at 500 grains when the large hollow point pin is used b
Depending on what you hope to accomplish, I don't see much advantage going over 500-600 grains.
I had a NOE 513-888 mold at one time, but sold it to someone on here. I usually shoot 450-600 grain cast boolits. After shooting those, I just didn't see what an extra 200-325 grains would get me excep emptying the pot faster.
What is your twist rate? Mine is a 1-14 twist better suited to the lighter boolits, although the 513-888 was supposed to be stable as well.
If you want to try some boolits, I have the 513-580 spitzer gas check and plain based as well as two MP 640 designs, a 450 GC HP and the 525 plain base HP.
I Have a couple of NOE 650 Round nose, and a 525 HP... They drop nice and very consistent boolits. Been Shooting 645 Gr Pulls. They work well too.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |