Fairly new to powder coating but I perfected a process for me. I have loaded and shot some PC 40's about 4 to 5 months ago and I didn't change my seating depth I don't believe. Will check the batch I have loaded up but my question is about some 10mm that I'm setting up dies for. Was aiming for the 1.25" OAL for a 200g semi wadcutter. But after achieving that, the bullet is seated too deep in my opinion. Which had me wondering if anyone changes their OAL after PC?
I will naturally experiment and gradually progress to be safe but PC thickness I would imagine vary depending on the coat of course. Just wanted to get thoughts or opinions.