WTS/T .243 dies & parts, molds, sizers

[gunwonk]

Got these as part of a larger deal, and don't shoot .243 myself, so offered here:

• Lyman 24R M-die, complete, die body used/VG, 24R plug & stem NOS (from a Lyman replacement parts kit), $15 + shipping -- SPF
• Lyman 24R M-die plug only, NOS (Lyman parts kit), $5 + shipping
• RCBS bullet puller collet, 6mm (no box), $5 + shipping -- SPF
• NEI 75.244 GC, 75 gr, 2-cavity, brass blocks (note: box says ".247") + correct Lyman #7 top punch, $65 + shipping -- SPF
• Lyman 245496, 85 gr, 2-cavity (Loverin style), Lyman grey box, $40 + shipping -- SPF
• RCBS .243" H&I sizing die (no box), $15 + shipping
• Lyman .244" H&I sizing die, $15 + shipping -- SPF

I will, of course, combine shipping. In particular, any number of the small parts would get a free ride with either or both molds, because those would be going USPS flat rate.

Pics:

.243 M-die, extra .243 plug (mounting stud is 8-32), 6mm RCBS bullet puller collet:


NEI 75.244 mold blocks + top punch. Note these are brass blocks. This mold has been used, but not much.



Lyman 245496 mold blocks. Note the incorrect (too long) 10-32 Allen set screw -- this is an older 10-36 mold with a forced replacement 10-32 set screw. Cavities good (note graphite mold release compound), alignment tight, just a little bit of peening on the alignment holes, but the pins have not been hammered. Screw heads not perfect, but not bad.


RCBS .243" and Lyman .244" H&I sizers:


Shipping would be $10.40 for a SFRB, $10.60 for a padded flat rate envelope, or $17.05 for a MFRB. The mold boxes won't fit into an SFRB, so for those I'd suggest a padded flat rate envelope, and I will take steps to protect the boxes. Shipping small parts only might be a little less, depending on how many, but I'd have to figure it out case by case. Or you could try for a free FTF, if you're in central NC.

Any questions, need more pics, etc., please feel free. (And yes, I'd be open to trades, see partial want list below, PM for more.)

Thanks for looking.

--------------------------------
A couple of items from Gunwonk's crazy long shot want list:

• old Ideal or Lyman 22536 bullet mold, 60 gr version (5 grooves)
• old Ideal or Lyman 25716 bullet mold, 140 gr version (8 grooves)
• Lee collet neck sizer for .350 Remington Magnum

[michael.birdsley]

I’ll take the Lyman 245496 .243 mold for $40 and the .244 sizing dye For $15. How would you like to be paid ?


Sent from my iPhone using Tapatalk

[michael.birdsley]

Actually, I’ll take the bullet pulling collet also


Sent from my iPhone using Tapatalk

[blltsmth]

I would like the NEI brass mold please! PM to follow.

[gunwonk]

All PM's answered.

At the moment it appears that everything is SPF except the M-die plug-only, and the RCBS .243" sizer.

Thanks everyone, for your interest.