Here are a few more molds up for sale. They are all functional in some capacity, complete, lock up good, no seized screws, etc. All prices are plus shipping (USPS Flat Rate) and I will combine shipping where possible (2 molds will fit in a $10.80 SFRB). Prices are best reasonable offer.
EDIT: Prices now include shipping!
1. Lyman 410 32 PB SWC. A few samples of bullets found in the estate weighs about 207gr and about 0.412”. Excellent condition inside and out. Cavities look perfect. Discontinued mold by Lyman, popular for the 41 Mag. Asking $140.
2. Lyman 429215 GC SWC 210gr. One cavity shows pitting on one half. Others show some “texture” from past surface rust. Might make a decent hunting/plinking bullet. Cast bullets may not look any worse out of these cavities than the ones you can buy in bulk that have been packaged and shipped. Asking $65.
3. Lyman 429244 GC SWC 255gr. Lots of “texture” in this one too. Probably good enough for a hunting/plinking bullet. Asking $65.
4. Lyman 429421 PB KEITH SWC 245gr. Again, cavities show lots of texture, but edges look crisp and should cast a good hunting/plinking bullet. Asking $65. SOLD toSig556R
5. Lyman 452423 PB SWC 238gr. Makes a great light 45 Colt load, designed for 45AR. Cavities have some texture and pitting. Plinking or hunting capable. Asking $65. SOLD to HARRYMPOPE
6. Lyman 454190 PB RFN 250gr. Popular for 45 Colt. Pits, funky sprue stop screw. Probably the worst of the ones listed. Would still harvest a deer. Asking $55. SOLD to Markopolo