Easy Big Batch Powder coating???

[414gates]

When speaking of a document tray, are you talking about the In-Out Basket that would be on an office desk?

Yes.

I have these exact ones.


https://www.amazon.com/Greenco-Docum.../dp/B01IRNTO26

Coverage is good. It's not perfect on every single bullet, but it'll do.

[BamaNapper]

I totally agree with the idea of there being two camps, those wanting lots of boolits as well as those on a quest for the perfect boolit. I put myself in both camps. For 9mm I mostly want ammo that hits the paper at 10 yds. The dump and bake method is fine for those boolits but I do limit myself to one layer in the oven (at 400 degrees as recommended). But when it's time to PC boolits for a rifle where I'm pushing them harder and farther, the boolits get tweezed and stood up in the oven for accuracy.

Imperfect PC in the pistol gets shot as is and I've never had leading issues. I'd never know if accuracy was off by an inch or so shooting concealed carry drills with a 3" barrel.

[Charlie Horse]

I could see using the bulk process for short range handgun loads. If they will hit the metal plates or bowling pins - then why not use this method? Could be another tool in the toolbox. I'm going to give it a try.