Does anyone know if the plungers are close in size and diameter??
Same with the springs. I've searched and no luck.

This is in reference to my previous post about Krag magazine cut-offs.
I'm trying to eliminate the slop from the ON position. The plunger is staked and it is pretty deep. Deep
enough I think to give me room to fix the wobble of the cut-off.

I need about .060 more length. I can get a 1903 plunger, but not an 1898 Krag plunger. If the springs are the same,
I'm good to go. I can turn a plunger from drill rod in my Flexshaft handpiece.

Suggestions are welcome. Thanks folks!!

Shiloh