what is the consensus on best 300 blk mold

[mike_kaleigh]

Haven't been here in a while, but was wondering what are the better molds for 300 blk, i just got a new barrel and dies, (ar15). Barrel is an odin works 16" pistol gas 1-8 twist. what have you guys had the best luck with, hoping to get plane base 200ish grain bullet and i only use ww lead. I do have a lee 160 tl for ak but not sure if it works ok for this with feeding. suggestions?

[reddog81]

My favorite is the NOE K31 311-195 RF. The NOE version of the 311299 is also a good one. My only complaint about the K31 mold is that I bought the 2 cavity mold instead of 4 or 5 cavity.

[KenH]

I would think "best mold" for 300BO would depend a lot on sub-sonic or full speed ammo? You mentioned the barrel length which also factors in.

[PositiveCaster]

“Best luck” for what? Accuracy? Function? Hunting? Subsonic or supersonic? Best looking? What is important to the OP, all we can do is guess….






.

[imashooter2]

Through many threads, I have yet to see consensus. I like the Lee C312-155-2F.

[mike_kaleigh]

“Best luck” for what? Accuracy? Function? Hunting? Subsonic or supersonic? Best looking? What is important to the OP, all we can do is guess….






.

i am going more for subsonic and good function in ar15, i use hitek if it matters

[44Blam]

I like the taco mold...
https://noebulletmolds.com/site/prod...10-225-rn-ce4/
I to hi-tek these and they feed 100%. I shoot them over a little 2400 at about 1050 fps. It is super easy to shoot.

[mike_kaleigh]

I like the taco mold...
https://noebulletmolds.com/site/prod...10-225-rn-ce4/
I to hi-tek these and they feed 100%. I shoot them over a little 2400 at about 1050 fps. It is super easy to shoot.

that was exactly what i was looking for, btw what is your twist rate, mine is 1 in 8 so i should be good.