Does anyone know what thread pitch the lyman 310 dies in calibers 50-110 and 50-70 are...
ie 5/8-30 , 11/16-30 etc etc
Does anyone know what thread pitch the lyman 310 dies in calibers 50-110 and 50-70 are...
ie 5/8-30 , 11/16-30 etc etc
Although I’ve collected and used 310 tools for over 40 years, I have to admit I’ve never even owned a single piece of the near-mythic “large diameter” 310 stuff. I’ve seen the small diameter stuff a couple of times but the big boys have to date eluded me.
I have seen discussions (and some “crowing”) from people on the Casting and Reloading Hand Tools forum and on the Vintage Reloading Tools forum here, and IIRC, on the Ideal forum of the ARTCA.com website. They are rare enough that they merit a little bragging. Also, a member here, BrassMagnet has accumulated a bunch of 310 stuff and it might be worth a PM to see what he knows... tell him “Froggie sent me!”
Froggie
PS Although I don’t have one, I’d bet a picture of Geo Washington to a pastry with a hole in it that regardless of the major diameter the threads will turn out to be 30 tpi - Ideal and later Lyman seem to have been stuck on that!
"It aint easy being green!"
Yes,
Last edited by Mike8623; 06-23-2022 at 10:17 AM.
I have a set of each. Did'nt realize they were hard to get.
You would think someone out there that has a 310 die in 50-70 or 50-110 could mic the outside diameter of the die and post it.
Well surprise, surprise I just found in my stuff an adapter that i have been trying to duplicate....exact thread pitch needed and fits my 50-70 and 50-110 dies. No idea where i got it or who made it. I also ordered a couple of custom taps, should have all this done and wrapped up by week after next.
Well surprise, surprise I just found in my stuff an adapter that i have been trying to duplicate....exact thread pitch needed and fits my 50-70 and 50-110 dies. No idea where i got it. I also ordered a couple of custom taps, should have all this done and wrapped up by week after next.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |