my 116 savage has to have full length sized brass as it has a tight chamber .no problem as it shoots great. just open the bolt and use fully sized in future.
my 116 savage has to have full length sized brass as it has a tight chamber .no problem as it shoots great. just open the bolt and use fully sized in future.
I would shoot it, and then see what needed to be done. Just as a precaution, before firing, you might want to tap the bullet a 10th of in inch back into the case, using a 1/4 inch steel rod wrapped with tape to protect the bore. This can help prevent a "stuck in the rifling" pressure event, though if you have a compressed load, don't try it.
_________________________________________________It's not that I can't spell: it is that I can't type.
We still don't know the latest on this project, has the round been fired, removed, or what? However, it's stuck in there for some reason....
Driving stuck rounds out from the muzzle is never a good idea, although many have gotten away with it. What happens is that very often the bullet will be forced back into the case and further expand whatever it is that has proven too tight. They make a tool that clamps around the rim of the cartridge and which has a long threaded rod on the rear. A slide hammer is on the rod, kind of like a pencil through a donut, and a big nut on the end for the slide hammer to impact against. That, if properly and tightly clamped onto the rim of the cartridge, will infallibly pull the stuck round out of the breech when the slide hammer forcibly smacks the nut at the rod's end. If you try the rod-from-the-muzzle method, and are unsuccessful what have you got then? Firing such a compacted round, and the higher pressure the compaction
would create might be a life-altering experience. And if it should fire from being hammered the rod is heading out of the barrel your way.
DG
Watching, wanting to know
NRA Benefactor 2004 USAF RET 1971-95
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |