Can't find any place that has any in stock.
Looking for 40 to 560 of them.
Would rather trade for them.
Can't find any place that has any in stock.
Looking for 40 to 560 of them.
Would rather trade for them.
Offer pulled
Last edited by HARRYMPOPE; 05-07-2022 at 06:27 PM.
Your mother was a hamster, and your father smelt of elderberries
Last resort - convert milt brass to boxer --
If i recall correctly, from the late 50s --- italian brass is a berdan size between boxer small and large, about 204 or so -- also just drilled out and used shotshell primers -- all a bit of bother though --
Can't 30/06 brass be used if the rims are turned down?
Offer pulled
Last edited by HARRYMPOPE; 05-07-2022 at 06:27 PM.
Your mother was a hamster, and your father smelt of elderberries
Tomorrow I am picking up a fairly large stash of ammo and reloading from my buddy's widow.
I know I saw some ammo, brass and En blocks in the mix. Remind me latter in the week to find them.
if you have a lathe the easiest way to make 6.5 or 7.5 carcano brass is from 220 swift brass. you will have to turn down the rims and also deepen the extractor groove. as for opening up the necks, you can use the 6.5 carcano sizing die but use lot's of lube on the case necks,. HTH
Rick
I found some.
Thanks
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |