Okay, another project in the works - converting an 1862 Pocket Police from 36 C&B to a .32 S&W cartridge. Plan is to line the .36 (.375) barrel with a .32 barrel liner (I know that the twist will not be optimal using a .32-20 liner but considering the practical shooting distances it may not make any difference). Loads will be BP or equivalent pressure smokeless and 85-95 grain cast bullets. I have the BP cylinder machined down and drilled through and .32 liner cut for the chambers. Next step will be to epoxy the liners into the cylinder and then cut the chambers. Also have the back plate spacer machined. Plan is to use a fixed firing pin attached to the hammer similar to some of the original conversions with two small rivets and no loading gate latch, just an open loading gate cut into the back plate spacer.