A short time ago, I swapped out my depriming setup to sized bullets. During this time I was sizing different diameter bullets 25-45 cal and someplace along the line the bullet solder wasn’t running returning back far enough to drop another bullet. So I installed a wire into the spring that I had made up and all was fine.
Last night I sat it back up for depriming and even with the wire trick it’s not feeding cases. I have the case feeder mount almost touching the press. The slide assembly looks clean and I didn’t notice any burrs or defects.
Tonight I’ll give it a shot of Hornady one shot (with DynaGlide Plus) cleaner/lube to see if that helps. Just thought I’d check and see if anyone else has had this issue/repair