Haven't seen any activity on this page for some time, so I thought I would try to start some.
In an effort to conserve a few kilowatts of power, I may have made an error in my selection of smelting furnaces. I have opted to go with a Lee 220V version of their pot. {I tend to over-think all things electrical} I put in a 30amp dedicated circuit, with appropriate cable, 220 plug & receptacle ect. I.ve read several comments here about the "accuracy" of Lee's heat control, or lack thereof. Unlike some others, my source of lead is slim, so I only have about half of the pot full, and it will take most of an hour to melt. I know I'm probably doing something wrong, but I can't think what it might be. Any suggestions out there???