Anyone have experience with this combination, I would sure appreciate input.
Thanks,
Sam
Anyone have experience with this combination, I would sure appreciate input.
Thanks,
Sam
Here's some vids:
https://www.youtube.com/results?sear...on+dillon+550+
I use one on a single stage for sizing bullets but modified it, but I modify everything.
Size/Prime a few cases when starting off with a progressive and put them aside. You can plug them back into the process when a bad/odd case screws up in the priming station and continue loading.
I used a Lee bullet feeder, by far the least impressive Lee product I have ever used. That’s not because I am a Lee basher, I was able to figure out how to get a Loadmaster to load 100 rounds in under 4 minutes. Still couldn’t figure out how to get the bullet feeder to work for more than a few hundred bullets.
A good “finger” design would do it.
Egads... what's the hurry?
Regards,
Gary
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |