MP 413-265-WNFP; your experience and loads

[Onty]

Would like to hear your experience with boolit for 41 Magnum, MP 413-265-WNFP:



https://www.mp-molds.com/product/mp-...d-multichoice/

Since this is heavyweight for 41 Magnum, and would like to shoot it full throttle, I think that gas check version should be the way to go.

I would appreciate if you list your loads, boolit (PB or GC), revolver (barrel length also), muzzle velocity, and accuracy on 25 yds. If you had a chance to test on longer ranges, like 50, 75 and 100 yds, please list those results too.

Thanks

[Wheelguns 1961]

This bullet is my 41 mag deer killer. I shoot them in my 5 1/2” ss blackhawk bisley. They load long, and fill the cylinder. I use the large hollowpoint version, and they come out right around 250 grains gas checked and powdercoated. I have shot them to 50 yards with good accuracy. I think my c.o.l. is around 1.725”. I use my 45 colt blackhawk more often, but this one is in line for a hunt this year. I load them over 17.0 grains of 2400 with a wlp primer. I haven’t chrono’ed it yet but it is a thumper.

[chsparkman]

I have two molds, in both solid and HP. Both are GC. I use these in my Bisley Hunter. 18.6 grains of 4227 is my load. I got a deer with a solid 5 years ago, and I'm going to have hollow-points with me next Monday for the opening in WV. It's a very accurate boolit.