I have a master caster , I’ve put a new orifice plate to match the double Mould .
But apart from a very tiny tendril no lead is coming out.
Suggests, thoughts
I have a master caster , I’ve put a new orifice plate to match the double Mould .
But apart from a very tiny tendril no lead is coming out.
Suggests, thoughts
It could be plugged with debris, or the temperature isn't high enough to allow the alloy to flow. I made a tool with a wire just under the size of the orifice bent at a 90 Degree angle to clear debris. Sometimes, hitting the orifice with a propane torch will take care of freeze ups after adding more alloy to the melt which has lowered the temperature in the pot.
Hope this helps.
Fred
After a shooting spree, they always want to take the guns away from the people who didn't do it. - William S. Burroughs.
Have you tried adjusting the plunger, lever travel, etc?
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |