Lee PrecisionInline FabricationWidenersLoad Data
RotoMetals2Reloading EverythingTitan ReloadingRepackbox
MidSouth Shooters Supply
Results 1 to 2 of 2

Thread: 6mm round nose 112 grain questions.

  1. #1
    Boolit Master
    Join Date
    Jan 2018
    Posts
    2,515

    6mm round nose 112 grain questions.

    Howdy all, I will very shortly run out of my hoard of the bullets in the title. Does anyone know of a forming die that will produce this nose profile? I don't care if it is exposed lead tip or full patch (not necessary to perform as hunting bullets). I have a project coming up early next year, and I have tried every alternative that I can think of and not been able to attain the feeding reliability that is required. Yes, I have cast for it but can't seem to get them to feed either.
    Thank you!

    Edit: I am an EXTREME novice to swaging - apologies if my questions are basic!
    The attached picture is an approximation of what I am looking for.
    Last edited by cwtebay; 10-17-2021 at 12:17 PM.

  2. #2
    Boolit Master


    Join Date
    Sep 2007
    Location
    East Texas
    Posts
    3,624
    That should be close to the profile of a 6mm ball end mill!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check