310 Special Handle

[dsh1106]

Hi

Does anyone out there have at set of the 310 handles that is for the "larger" 310 dies?
I believe these fit the 348 Winchester size cartridges.

I would like to know the diameter (ID) of the threads in the handle.

Thanks
Scott

[Green Frog]

I've heard of these, but never encountered a set in the wild. You might check with Pressman and with Brass Magnet, and of course Rick at the 310 shop. Maybe, just maybe one of them will be able to provide the info you need.

Your Phriend the Phrog

[dsh1106]

Thanks Mr Phrog, good to hear from you.
PM me, I may have few odds and ends for you, I did some more cleaning.

Any way, I believe I have two adapters for these larger dies so they can be used them in a standard press, just like the smaller 310 dies.

Scott

[Pressman]

Lyman die sizes: Small, .381" x 30tpi; Medium, .609"x30tpi; Large, .652"x30tpi

[Mk42gunner]

I was going to say that if you have them in hand a simple measurement should tell you the size, or at least get you close.

Mr. Barlow must have really liked 30 TPI, it shows up a lot in his tools.

Robert