7/8"X14 Bolt that will fit my loading press threads? It is the same diameter and thread as a standard reloading die, and should be fully threaded. length? Probably 3-3 1/2 inches.
I will use it firelapping my revolver, so I don't gunk up my good seater dies with the abrasive. I have a can of abrasive I got from Veral Smith some time ago, which should work well, and some of Hornady's swaged 158 gr. SWC, BHN~10 which should work fine, loaded to minimum .38 spl. velocities. (I hope)
I have had no luck on the internet, probably because I don't know the specification for the thread...standard, coarse, or fine. I had an order in with Beartooth Bullets, but after 5 months, and no response to my inquiries, I cancelled.
Any suggestions?
Thanks!