I was on Amazon a couple weeks back and accidentally ran across a tool called a 'Lab Jack'. They come in all sizes and heights of extension.
I thought to myself..."hmmm, what a handy shelf for a mould, easy to adjust...bla, bla, bla."
So I ordered a small one...
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
I have another project going at the moment so all I've done is set it under the spigot to see what I could see?
I was talking with a friend on TRN about having to make some kind of rail to index the side of the mould to...but after seeing how visible the spigot is on a 10# pot, I'm not sure I want to even go that route...I can see the 'X & Y' position of the sprue hole and the spigot easily.
When I get time to figure out a way to fasten the jack, I'll post again about that (gotta finish the PC oven controls first)...
Another PC oven surrenders to a PID ...
https://castboolits.gunloads.com/sho...nders-to-a-PID
Just thought I would post this to see what others may think about a 'cheap-n-easy' mould rest for a Lee 10# pot? Any comments?