Anyone know the size of the small set screw for the sprue plate bolt on a MP brass mold?
Thanks.
Anyone know the size of the small set screw for the sprue plate bolt on a MP brass mold?
Thanks.
If you take a dog which is starving and feed him and make him prosperous, that dog will not bite you. This is the primary difference between a dog and a man.
I don't have a MP mold, but the thread are guaranteed a metric one.
Measure the outside diameter of the set screw with a caliper - the (approx.) measurements are:
0.24 = 6mm = M6x1
0.20 = 5mm = M5x0.8
0.16 = 4mm = M4x0.7
0.12 = 3mm = M3x0.5
Cap'n Morgan
Thanks Cap'n.
Asked MP and got a very prompt answer.
M4x4 DIN 913 (pitch is 0.7mm)
If you take a dog which is starving and feed him and make him prosperous, that dog will not bite you. This is the primary difference between a dog and a man.
I bought replacements at a business that specializes in fasteners. I bought multiple for like .25 cents each.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |