I ran into several problems yesterday in my casting & sizing & thought I would run it by the folks here. First I just got a new .225 - 62 gr. Mold from Noe, they make great molds ,I have several but, I cast for a couple hours & still had a 50% rejection ( wrinkled boolits).I was using a hot plate & run lead temp. All the way up to 800 & still lots of wrinkles.only thing I can figure is the large blocks that Noe uses with just 62 hrs of lead just not enough heat into mold. Next I started installing gas checks & was happy that they seemed to be going on very nicely. But, when I was sizing them I seen it was shearing the check & leaving a sharp edge at the bottom,enough to cause problems. My fix for this ,after several tries was to run them through .225 die check first , which leaves a domed check. This I fixed by running them through a .224 die nose first. This was the size I wanted them as I powder coat then size to .225 after. Ideas?