Sizing powder coated bullets

[fredj338]

I use a bit of Oneshot if my bullets have to go very far down in as cast size. It just makes it easier.

[tankgunner59]

I've never had to lube powder coated bullets before sizing.

[alamogunr]

Why not just squirt a pile with the lanolin/alcohol? Just asking because I'm getting ready to start PC.

[mdi]

I do much the same as Mr. LaRouche. A couple of my 44 cal molds drop a bit over .434" and with PCing sometimes they can get tiresome pushing them down to .431"...

If you are sizing down a "lot" and the sizing gets "difficult" the there's no reason not to lube. None of the lubes I use for case sizing or bullet sizing will harm the baked on PC...

[Walks]

I've used Hornady One-Shot and PAM. I lay a double handful of PC'd bullets on a hand towel and spray. Five minutes later I pick up the edges of the towel and roll the bullets back and forth and size away.
PAM is cheaper.

[Helka]

Why not just squirt a pile with the lanolin/alcohol? Just asking because I'm getting ready to start PC.

That's my recipe for lubing cases, haven't had to lube PC'd boolits yet but if i need to that's what i would use. Smooth as silk.

[Smoke4320]

Hornady one shot spray lube will work just fine