ive been thinking of cutting the gas check ridge out of one or two of the cavities on this 4 cavity mold.
ive found that I don't really need a gas check on bullets at 1400 fps at least I get away with no gas check on H&G 503's at full power out of the super red hawk. but feel gas checks are probably necessary when loading in the 444 at 2000fps
I'm hesitant to alter one of Miha's works of art.
opinion? should I just save up and order a new mold without gas checks or alter the mold.
if cutting out the gas check ridge I'm not sure if I have a drill the correct size, without having a mill can it be done properly?
a number 57 drill bit is .430, I'm thinking that's about as close as I can get and I lube size at .431