WTB/TF: Steel Reloading Dies And Lyman M Type Dies

[Lefty Red]

Like the title says, I want STEEL dies not CARBIDE ones. Can even trade carbide for steel ones in the calibers needed. Looking for 38Spec, 44Spec, and 40SW.

Really just need the Resize dies in the above calibers, but will take the whole set if in good condition.

Also Lyman M Type Expander Dies in the above calibers.

Thanks for looking,
Jerry

[smithnframe]

I have an rcbs 38 spl steel sizing die…….PM me.
Also a 44 spl.

[bigwagon]

I also have steel sizers in 38/357 and 44 mag/44 spec. What do you have for trade?

[Conditor22]

"Can even trade carbide for steel ones in the calibers needed"

[bigwagon]

"Can even trade carbide for steel ones in the calibers needed"

Are you the OP? Maybe he has something else he'd trade.

[Lefty Red]

Problems?

To clarify, I can trade like caliber resizing die. Looking for steel, can trade a carbide or buy it.

Lefty

[Char-Gar]

Good move going to steel sizers in 38 and 44. However a I doubt a steel sizer in 40 S&W would make much difference. Is the 40 S&W even old enough to have steel sizers made?

[Lefty Red]

Good move going to steel sizers in 38 and 44. However a I doubt a steel sizer in 40 S&W would make much difference. Is the 40 S&W even old enough to have steel sizers made?

Probably not. I was hoping for maybe an oddball 10mm one. Going to use my 41 mag resizer to see if it makes a difference.

I know in 45LC and 41mag is made a big difference, and much cheaper than Redding’s Dual Ring Size.

Lefty

[contender1]

I have several sets of steel dies I just got in a large purchase. Still going through them. But I do have a RCBS set of .38 spl, .357, .41, & .45 acp. I have a Lyman set of .44 spl/mag.
If interested in any of these sets, PM me.

[Tim357]

I have a Lyman steel .38/.357 sizer to trade for a carbide sizer. PM me if interested

Edit: I also have RCBS steel sizer for .38/.357

[Lefty Red]

Thanks, I’m closing this thread up. Have so many great offers and replying to PMs.
Lefty