Just got my Lee in the mail and got it setup, I am having an issue with shell holders not sitting flush in the press. When I bring the ram up it touches the shell holder in the back and leaves a slight gap in the front? These are Hornady shell holders, I believe that the shell holders are junk. I tried about 5 others and 1 sat flush, 1 I couldn’t even get into the press at all but it fit into my LNL press. Press press was gritty and had scratches on the ram but has smoothed out after messing with it for awhile. I also see my brass case hits the side of my die but the case will still enter the die. I can live with the other querks of the press but the shell holder things has me pulling my hair. I have an App press with the same issue. I have a metal lathe but I don’t think there is any way I could indicate the rear face and make a truing cut across the front to square it up.