I use the priming tool named in the thread title. I've always called it a bench priming tool. Everything has worked fine until this evening. I was about to wind down after priming almost 100 .38 Spec cases. when one stuck in the shell holder. I've tried everything I could think of without getting too heavy handed. The only things I can think of that may have caused the problem is(I'm embarrassed to say it) that I stuck an already primed case in the shell holder and tried to push home another primer.
OR, something happened to the priming rod. I've tried to disassemble it but can't get what is called the main ram out of the body casting. I don't want to destroy the tool. I bought it used from a member here and have used it on just about every thing that I don't load on the Dillon and some of them when I don't want to do a changeover.
Any ideas?