I carry a scandium .357 for CCW. The boolits I carry are the speer GD short barrel .357 and the speer .38 GD short barrel. Both rounds carry a 135 grain HP boolit. I'd like to have a mould made that can duplicate a 135 grain HP boolit load. The boolit would need to have a wide and deep lube groove below the crimp groove as firing these at 1000 fps, the wide lube groove would carry enough lube to help prevent leading in these higher velocity practice rounds. A round nose flat point configuration that contains the hollow point would be perfect!!! This boolit can look like most of the 158 grain .357 HP boolits being cut by NOE only I need a boolit that drops at 135 grains. Is there any interest from the list members about having a boolit like this be submitted to NOE or MIHA to be made ?? Any boolit Honcho's would like to chime in please ??
Ohio Rusty ><>