Does this gun offend you?

[Winger Ed.]

It's obvious, JB Weld the porting up, sand it smooth and you're good to go.

I used to know a guy who swore you could make a boat trailer out of JB weld,
but even he would probably think it wouldn't hold that much pressure in a straight drilled hole.

[Duckiller]

Tarus does make ported guns. #2 son has a Raging Bull. 454 casull with a ported 10" barrell. Even with the ports my children and I have decided that 10-15 full power loads are enough for one day at the range. Daughter has shot a bunch of 45 Colt loads, 165 grain lead,small amount of powder. Goes bang real good. She thinks it is the greatest gun going.

[fastdadio]

It would be a great candidate for a custom sheriffs model project. It wouldn't bother me a bit to take a hack saw to it.

[jonp]

Not "offended" but I don't think that porting is needed or looks good. The wood is very plain. I'm sure I wouldn't buy it but someone might for some reason.

[jonp]

I used to know a guy who swore you could make a boat trailer out of JB weld,
but even he would probably think it wouldn't hold that much pressure in a straight drilled hole.

https://www.youtube.com/watch?v=R3r0UZ7txzs Go to 10:45 for the pressure test but the whole thing is very interesting at least to me. This is a great channel

[Bent Ramrod]

If it’s a true factory offering, it’s an instant collector’s item. Wait until they’re remaindered, buy a half dozen, don’t open the boxes, and store them for 20 years. They’ll appreciate faster than GameStop stock.

[ddixie884]

It doesn't offend me but I wouldn't buy one........

[Peregrine]

I'm normally a fan of kind of ugly unusual design choices in firearms but this made me cringe.
Not for me. Not offended, however.

[rbuck351]

If it was in 41mag instead of 10mm, I'd buy it. I could build a thin steel sleeve to slide over the holes if it made to much noise