Another Lee 20# bottom pour.
Another "kit" PID controller set up for controlling multiple devices.
Lee 6 cavity molds. Probably start with 356-120-TC for sure plus likely TL358-158-SWC, 429-214-SWC & 452-200-SWC.
Some Lee push through bullet sizing dies, 0.309, 0.314 and 0.358 for sure.
Another dirt cheap (last one was $5) used toaster over - controls to be gutted and adapted to control on same PID used for lead pot.
A couple of pounds of powder coat (two colors) some black Airsoft BBs, some good shaking tubs, a teflon cooking sheet and the other misc items for doing ASBB PC.
A bottle of 45-45-10 for tumble lubing (all loads light enough to not require PC).
A Lee turret press and Lee reloading dies are good enough for me (if the reloading stuff is gone).
Now, the above would all be good stuff for a newbie.
For me, I would also be pretty quick at getting some more advanced stuff such as:
Lots of Lee blank molds to make my own custom NLG molds. Converting one of these to a 4 cavity that drops a lightweight (~75 gr) 32 cal in RF would be a priority (Lee has one six cavity offering in 32 cal and I don't want a 93 gr RN). 7mm, 30 cal & 35 cal rifle molds would be next.
Another 7x14 mini-lathe (if needed due to my current one being lost with everything else). Must have accessories include a four jaw independently adjustable chuck and a lever type dial indicator for getting mold blocks chucked up (and re-chucked if needed) perfect.
A selection of W1 drill rod for the new D reamers I would need to make.
A couple of 3' pieces of 7/8x14 all thread to make new custom push through sizing dies etc.