I was wondering if any one on this site has used the SliXprings Scraper tool to remove the fowling from the chambers on a revolver?
The link https://www.slixprings.com/proddetai...prings-Scraper
If you have used this tool could you let me know how it works? I do shot a lot of 44spl in my 44mag revolvers and my wife does shot a decent amount of 38spl in her 357mag revolvers, and on occasion I do decide to shot 44mag loads and they will not feed until I clean the cylinder. I am also thinking of when I shot the wad cutters it will make loading 44spl RN difficult until I clean the cylinders. But I do not want to damage any of my old frame Ruger Vacaros , so I need to see if any one here has used this new tool.
Thanks for any replies