40gn 224 boolit molds

[Bad Ass Wallace]

Anyone know an "off the shelf" boolit mold maker that can make a 40gn 0.224 boolit for my 22 Hornrt?

[3leggedturtle]

NOE has a real nice 37 or 38gr FP mold. I spend too much time looking on his site.

[Intel6]

The closest you will get to 40 gr. is the NOE 37 gr. as most others are 45+ gr.

I have cast this one for years specifically for use in my magazine fed Anschutz .22 Hornets. It is the smallest bullet I make and is quite challenging to cast and size because it its so small.

In the pic below are a few culls I sized for examples L to R:

NOE copy of the RCBS 55 gr. .224

NOE 45 gr. .224 WFN - I also have this in a GC version

NOE 37 gr. .224

[Oily]

Miha had a group buy on the 37 gr hollow point 3 cavity brass. I have one and love it. Go to MP molds and see if he has any left over.

[Traffer]

Do you need grease grooves or are you powder coating?

[MT Chambers]

225107 was not accurate enough in my very accurate CPA .218 Mashburn Bee, but the hollowpoint was/is deadly with some creative lubing/sizing in my .22 airguns. In my pb guns Lyman's 224415 is tops even at high speeds.

[Bad Ass Wallace]

Do you need grease grooves or are you powder coating?

I will be powder coating, the price of "J" boolits has gone to $AU45/100 so powder coating a gas checked cast boolit will feed my little Brno and Mashburn Bee for years to come. I have already had great results with PC in my 223 Remington.