Velocity isn't all that. I am fixing to hunt elk next month with a 278 grain round ball over 90 grains of black powder. Ballistics on paper are not impressive, but the ball will pass through a cow at 100 yards.
Velocity isn't all that. I am fixing to hunt elk next month with a 278 grain round ball over 90 grains of black powder. Ballistics on paper are not impressive, but the ball will pass through a cow at 100 yards.
When you care enough to send the very best, send an ounce of lead.
I know we all like our cast bullets on this site, but there is a lot more to it than "bigger is better". There is no way to honestly quantify the effectiveness of a round based on basic mathematical formulas. Energy number, momentum numbers, TKO formula, etc. They are all junk.
Many, many, far too many are penetration is everything fiends. There is no doubt at all that a 44 special, 45 colt, 45 acp and so on are great hunting rounds with solid bullets, as they penetrate like crazy. What they do not have is the speed or expansion to cause a large wound channel. "Bigger is all that matters", is something repeated too often on this site. You state a 40 something caliber 200 grain bullet at 1000 fps vs a 200 grain 30 caliber bullet at 2200 fps. The latter would be a very strong 30-30 or a weak 308 round. I'll put a 308 winchester up against just about any handgun cartridge. More is more, and the 308 is WAY more.
Words are weapons sharper than knives - INXS
The pen is mightier than the sword - Edward Bulwer-Lytton
The tongue is mightier than the blade - Euripides
You right on the 22 rim fire , I read in different places that state that more deer are poaching with the 22 rim fire then any other cartridge. Like was stated is shot placement , also for the twist of the barrel is from what I read on here in different post is to match the bullet to the twist. I also found that out myself with one of my muzzle loaders and some other rifles.
Life Member of NRA,NTA,DAV ,ITA. Also member of FTA,CBA
You don't need speed to kill. If you did the .45acp in the 1911 would never have risen to the position it holds.
.45 caliber 200 + grain bullet moving at 800 to 1200 leaves 2 holes, in almost everything.
Speed makes life easy, ballistic wise. But if you burn the ammo, learn the rainbow, it will do the job. Look at the .45-70.
Large for caliber bullet, lots of practice, knowing you can put the round where it needs to be at the range involved is going to put meat in the pot more times than not. But the caveat here is putting in the time, knowing the rainbow, learning it. Learning to judge the distance fairly accurately.
And the best part is you can probably load those for 8-12 cents a round compared to 1-2$ per round for factory high speed rounds. I know which I prefer, YMMV.
I truly believe we need to get back to basics.
Get right with the Lord.
Get back to the land.
Get back to thinking like our forefathers thought.
May the Lord bless you and keep you. May the Lord make His face to shine upon you and be gracious unto you
and give you His peace. Let all of the earth – all of His creation – worship and praise His name! Make His
praise glorious!
We all know with a well placed shot with using just about any bullet/boolit will kill just about anything. It’s how far and how long you have to look for the animal without a blood trail. Going from hard cast to soft cast and boolit design will play a HUGE outcome in Kinetic energy transferred as well. Hard cast if not hitting bone isn’t going to expand and very little to zero energy transfer IMO. Most hope the “wide“ metplate will rip and tear through the vitals. I would rather cast as soft as possible and get as much expansion as I can with soft cast. Can’t wait to see how my 10.4 BH, 50/50 COWW and pure lead mix, 200 grain hollow point does on deer loaded at 2100 FPS. I’m sure it will work just as good as jacketed ammo because of the design and boolit choice. It shoots three in the same hole pretty consistently at 100 yards as well. I just read an outdoor life or field and stream article last month about casting up a soft cast boolit vs hard cast and how the soft cast. They talked about expansion and energy transfer with soft cast expanding boolit and how it aids in better blood trails and putting an animal down quicker vs poking a hole straight through with a non expanding hard cast boolit. It was a good read.
Last edited by Tripplebeards; 08-12-2020 at 09:05 AM.
The religion of KE: proposed by the ignorant, and parroted by the unknowing.
hmmm.......i just can't remember.
Ad Reipublicae his Civitatum Foederatarum Americae, ego sum fortis et libero. Ego autem non exieris ad impios communistarum socialismi. Ora imagines in vestri demented mentem, quod vos mos have misericordia, quia non.
To the Republic of these United States of America, I am strong and free. I will never surrender to godless communist socialism. Pray to images in your demented mind, that you will have mercy, because i will not.
MOLON LABE
So the flat nose soft alloy cast just increases the diameter part of the Taylor KO formula - KO still 'works'. FMJ is often illegal for hunting as it was designed to puncture more than flesh. Hollow point and 'tipped' bullets just try to allow expansion and fed into KO, yup. More damage. Head on VW bug vs semi - who wins? Obviously KO does work! I would shoot a hog with the 150gr gold dot (1400 fps expansion) for BO or my 145gr FN cast @ 100. Both are loaded for 2k fps. Twist really only comes into the equation for accuracy (at HV) and maybe terminal if it tumbles on the target (expansion?). Examine Chitown shooting stats, <10% die. Or how many shots LEO uses on bad guy before the problem solved? I hit the south end of a running northbound 150# hog with 40sw @ 20 yds (on the 3rd shot), 165gr TC hard cast broke front leg and out the gullet. He still went 100 yds. Buddy (and wife) use blazer 115 9mm and often empty the mag into one. They use ar15 for stand shooting, still needs more than one shot! Terminal difference? yup.
Whatever!
I have killed deer with expanding and with WLN solids-- and I have not seen much difference. I did shoot a boar and the solids made good and big holes but he was not so impressed- took 3 or four shots. The deer also had very large holes but the holes were where they belong, so end result was the same-one shot drt or near by--my state says use expanding bullets - so I do-- cast hps or cast soft points. lever gun or handgun ---But both can and will work.
I think this post was about how a cast bullet can make an ineffective cartridge into a decent cartridge for hunting deer with.
https://castboolits.gunloads.com/sho...48#post5316148
IF that author had used a conventional copper jacketed bullet, and hit the deer in the same spot, the bullet would have simply stuck inside the shoulder of impact. And required a follow up shot to dispatch the poor animal. Rather dismal result common with ultra fast low weight rifle loads, 223 243
But the usage of a cast bullet as a sane velocity give the hunter through and through penetration, structural damage, internal damage. And meat on the table.
Far too much of the modern hunting world is about muzzle energy, recoil energy, bullet energy, and ratios of velocity to impact energy to determine bullet performance.
The fact that a 30-30 and 30-06 can push the same cast bullet to the same velocity, hit identical twin deer in the same spot on the shoulder, punch the lungs out, can get nearly identical results after impact. Its a liberating thing for the person who gets suckered into going for the 80 grain 2500 fps "easy fragmenting" jsp load in their .243 deer gun who cant get exit holes on a deer. But its also a sucker punch as they realize that they havent gained anything by skipping out on a .308 or 30-30
"Lowly" You mean a 380gr HP at 1325fps with 1480 Ft. Lbs at muzzle and still over 1000ft. lbs. at 100yds? That's 150fps faster than a 240gr 44 magnum and twice the muzzle energy with a bullet 50% heavier. And its actually enjoyable to shoot (which a 460S&W is not....)
I agree that none of the various mathematical formulas truly represent the terminal performance of bullets. How many times have you heard you need 1000 ft lbs to kill a deer, and then seen the uncountable number of pictures of deer killed with .357s? You'd have to shoot a deer twice with a .44 Magnum to put 1000 ft. lbs into it! LOL
"We take a thousand moments for granted thinking there will be a thousand more to come. Each day, each breath, each beat of your heart is a gift. Live with love & joy, tomorrow is not promised to anyone......"
unknown
Taylor KO values only apply to FMJ solids used on heavy game like elephant, buffalo, etc.
USMC 6638
Hey, Larry G. ; Really hurts inside when you stop & think.
There is no "magic" to any bullet or caliber....To effectively kill an animal it first has to have enough penetration to get to vital organs from what ever shot angle is taken..then it has to be able to disrupt by the transfer of its kinetic energy to those organs. The more energy transferred the more damage done.. Both momentum AND energy are important...My .243 kills with a rapid deceleration of the bullet and the subsiquent expansion/disintegration of the bullet resulting in a very rapid energy transfer..but it cannot be counted on to penetrate and continue to deliver that same energy release. My 255 grain .45 cast bullet with large flat meplat will penetrate from almost any angle but delivers its energy over a longer path, though the rate of energy transfer is much less than the .243...most .30 cal and above rifles have the ability to penetrate AND release high amounts of energy via jacketed expanding bullets....Most handguns that will fit in a holster do not...They have to depend on penetration of a fat bullet with a big meplat...I have killed deer with .357 caliber 158 grain JHP at 1950 fps and a .45 caliber 255 grain hard cast Keith style bullet at 1200 fps...Some run a little ways..some drop on the spot...but both bullets were able to GET into the vital organs...and hade ENOUGH energy to create disruption..
Last edited by kingrj; 12-18-2021 at 06:55 AM. Reason: spelling erro4r
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |