First try at this hope I get it right. I will take a .432- 2 cavity HP GC (all pins) tinner at wowway dot com
First try at this hope I get it right. I will take a .432- 2 cavity HP GC (all pins) tinner at wowway dot com
put me down for a .432 4 cavity gas check hollow point all pins and 1 set of handles.
Bri2906 at aol dot com
I’d like to get in on this one if I may.
rocpyro at gmail 432 HP, PB 4 cavity and handles.
Bumpity
Sent from my iPhone using Tapatalk
Does this design address the issue we had with the oversize gas check shank on the C434-250 Lars?
I just checked crimp to tip length for proposed boolit. As I could see, looks like it's about .400".
Now, here is SAAMI spec for 444 Marlin:
If we take minimum case length as 2.205" (2.225"-.020"), and maximum OAL 2.570", crimp to boolit tip is .365".
Loaded 444 Marlin round using Larsen C432-300 RF will be at least .035" longer than maximum length per SAAMI specification. Would this create a problem?
Bump
Sent from my iPhone using Tapatalk
I am interested in an answer to Onty’s question… since I want this for my .444 Lever action.
With that said.
I’m in since no one has pulled the plug yet.
I’ll take a 434 HP/NLG/PB ALL Pin/4 Cav Version with handles.
Red old spot at g mail dot com
57785
Looking forward to some powder coated, suppressed, fun.
Last edited by rcn11thacr; 02-14-2022 at 08:10 PM. Reason: Changes
Blackhorse Scout
Sunday bump for answers to questions…
Blackhorse Scout
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |