RotoMetals2Snyders JerkyTitan ReloadingReloading Everything
Inline FabricationLee PrecisionRepackboxMidSouth Shooters Supply
Load Data Wideners
Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: Lead Drain Pipe

  1. 01-23-2019, 10:59 PM #21
    Dusty Bannister
    Dusty Bannister is offline
    Boolit Master
    Join Date
    Jan 2011
    Location
    NE Kansas
    Posts
    2,433
    Should not be much of a problem. Interior use keeps the outside of the pipes fairly nice. Did you add any wax to the melt and light the smoke off? Extra heat that way. Maybe being a little too cautious with the melt temp? You are not going to hurt anything bringing the lead pipes and traps up to melt temp, but just turn down the heat when fully fluid. Dusty
    Reply With Quote Reply With Quote
  2. 04-06-2021, 10:55 AM #22
    LukeSrm
    LukeSrm is offline
    Banned LukeSrm's Avatar
    Join Date
    Mar 2021
    Posts
    2
    It's a good point of view.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check