This is the results of my very first attempt at paper patching.
It's a 9.3 x 74R The boolit is from Saeco #352 mould that Ben so graciously sold me. The paper is just my printer paper, 2 wraps. Base was not fully covered. 54 grains IMR 4064. The group was fired at 50 yd. (the one off to the right was my fault). When I got to the range I found I'd forgot targets and all I had were some Shoot 'n See dots and some cardboard. The 1/2" steel plate was out at 100 yds
All of your advice as been invaluable. Thanks again. Steve