Titan ReloadingSnyders JerkyInline FabricationReloading Everything
WidenersRotoMetals2Lee PrecisionLoad Data
MidSouth Shooters Supply Repackbox
Results 1 to 2 of 2

Thread: DIY bottom pour pot thoughtHi there

  1. 01-13-2017, 02:56 PM #1
    marky123
    marky123 is offline
    Boolit Buddy
    Join Date
    Jun 2007
    Posts
    150

    DIY bottom pour pot thoughtHi there

    Hi there
    If you were making a simple pot,could you put the element inside it in contact with the lead?
    IE if you were using an electric fryer element and controller.
    regards
    MARK
    Reply With Quote Reply With Quote
  2. 01-13-2017, 02:59 PM #2
    Doc Highwall
    Doc Highwall is offline
    Boolit Master
    Doc Highwall's Avatar
    Join Date
    May 2007
    Location
    Ct
    Posts
    4,615
    No it would be too hard to scrape the bottom clean when fluxing.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check