If I make a thick cylinder with a small hole in the base ie .200 and make a piston to suit,can I use it on a hydraulic press to make lead cores?
Thanks
If I make a thick cylinder with a small hole in the base ie .200 and make a piston to suit,can I use it on a hydraulic press to make lead cores?
Thanks
Yes you certainly can. That is how lead wire is made.
Be sure to give the hole a good lead, and a bit of taper to the exit. Make the piston fit close, a running fit will do fine.
The extruded lead can get hot if you move it quickly, so be careful handling the output. Heating the cylinder & base stock to about 100c will reduce the pressure required to extrude...
B.
It is also a VERY GOOD IDEA to lubricte your lead. I used to buy .550 diameter lead wire that was "lubed" with some type of heavy oil.
bohica2xo,
Thanks for the assistance with the idea.Will try within a week if possible.
Southron Sanders,welcome and yes lube will help !
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |