So I got around to finally opening my new Mihec molds and I ordered them with all the pins and when I opened the box I was once again stunned by the craftsmanship of these molds. Then I saw the bag of pins and c-clips. Both molds are four cavity brass molds, 359640 and 434640. I have never seen hollow point molds before let alone set them up. Looked on u tube and saw a couple videos I could not bare to watch, one guy was wacking the be Jesus out of mold with some type of log impersonating a sprue plate mallet. The next guy I could barely hear but I absolutely and clearly heard the mold faces clanking together after he dumped the bullets. Sooo...is there any older posts that anyone might be aware of that walks somebody through setup and best practices with the Mihec hollow point molds? Thanks and much appreciate personal observations using these fine molds. Thanks again.