Powder options

[semtav]

Need to go out of town a while and wont be where I can pick up powders at my convenience so I was trying to take a few that would be good candidates.
I'm shooting a Siamese 8X52 Mauser with the KAR 8mm mould.

So far I have in Ball powders Winchester 748 and H1000. Any other recommended powders?
I prefer to have full case loads.

25 gr of 4895 was working well with the grease groove bullets at slower velocities, but Im looking to up the speed quite a bit with the paper patched loads.

thanks
Brian

[CJR]

Semtav

I like W748 and W760 in my PPCB loads.

Best regards,

CJR

[semtav]

Thanks CJR
I just grabbed a bunch of slower powders to try to.

[303Guy]

I can get W780. I've only tried it in my test tube but it it did burn at quite low load densities (about 60%). I'm guessing it's the next step slower than W760. I was thinking it might produce usable velocity at low pressure and a near full case.

I wonder how that H1000 would work for you? Just don't go jumping in the deep end with it - I have no experience with it.