I have a couple of blank molds that I purchased last year. I want to drill them the make heavier cores for swaging. Can I drill these with a standard Ti bit or do I need a reamer?
|
   
   
|
|
I have a couple of blank molds that I purchased last year. I want to drill them the make heavier cores for swaging. Can I drill these with a standard Ti bit or do I need a reamer?
__________________________
Thanks,
---Frank---
As long as you are not looking to cut an exact diameter a drill bit will work fine, just make sure you are dead on center of those blocks.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote