Anyone ever mount a globe front sight on a contender barrel? What parts did you use and how'd you do it?
Anyone ever mount a globe front sight on a contender barrel? What parts did you use and how'd you do it?
Some where between here and there.....
Kind of:
Ken Light Manufacturing sells sight sets for IHMSA shooters that may be suitable for you.
http://www.kenlightmfg.com/products.html
Boolits= as God laid it into the soil,,grand old Galena,the Silver Stream graciously hand poured into molds for our consumption.
Bullets= Machine made utilizing Full Length Gas Checks as to provide projectiles for the masses.
http://www.cafepress.com/castboolits
castboolits@gmail.com
I have seen target shooters who turned the muzzle to fit a barrel band. then mount what ever kind of front sight you want including ladders and other adjustables. would look like this.
Brownells sells the bands. I'm sure there are less expensive ways to mount a globe but this gives you a lot of flexibility with your site dope and globe inserts.
Last edited by danski26; 02-04-2009 at 06:05 PM.
Semper Fi
Somewhere I have ramp with a dove tail that was ground down for a contender. Came off of a used barrel that I never got around to playing with. Heck, I think I sold you the globe that went on the ramp. If I can find it, I'll send it to you.
At one time, T/C sold a hooded front sight. I think it was for a short time and the globe was 1/2 to 5/8 inch in diameter. Might give them a call and see if they have any idears.
7br aka Mark B.
On the internet, I am 6ft tall, good looking and can dance.
I finally came up with a workable solution, not pretty but it works. I got ahold of an old lyman front sight from the small bore rifle club. Seems like one of thier bubbas long ago butchered a front sight while trying to fit it to the dovetail. I took that, ground off the dovetail, took the old rusty contender front sight I had and ground that down to just the base with screw holes. Then I brazed the two parts together. No pics at the moment...my camera is thrownin a hissy fit.
Some where between here and there.....
Is this a 10" or 14" barrel?
I have used the Williams Shorty Ramp & Lyman 17A(AHB) on the T/C. On a 10" barrel the front of the ramp needs to be shortened, as it hangs over the end(about 1/8"). I have one laying around here, PM me if you want it.
The Ken Light or Lansing are nicer, larger and pricey.
Jon
Jon
Col 2:13-17
Wut ta do with early barrels, the ones w/o screws? Are they soldered on? If so then I guess one could remove the old with heat and then D&T for the new, yes? Anyone ever sent one to TC to get this done?
BIC/BS
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |