I'm going to be installing gas checks and sizing Boolits cast from the Lee C312-155-2R mold. Do you guys put them through nose first, or upside down? seems like upside down would help seat gas check.
I'm going to be installing gas checks and sizing Boolits cast from the Lee C312-155-2R mold. Do you guys put them through nose first, or upside down? seems like upside down would help seat gas check.
What type sizing press???
Std. press...RCBS/Lyman......butt first!!!
I seat those in my lee .311 sizer nose first. They seem to seat on just fine. For my pop-can checks on 9mm I push them through base first.
War is peace.
Freedom is slavery.
Ignorance is strength.”
― George Orwell, 1984
I have a Lee classic press and Lee sizing die.
Depends on;
Alloy hardness: is the alloy hard enough that the bullet is not squished or bent when pushed through. If so I generally push base through first. This also is dependent on how much the bullet is to be sized from as cast.
GC does not seat all the way before sizing. If not I push base through which seats the GC flat on the bullet shank base before crimping. If alloy is hard enough.
Alloy is soft and GC slips on completely before sizing/crimping I push them through nose first.
With PB'd cast I always try to push base first.
Larry Gibson
P.S. I always lube the bullets before sizing/crimping
With that design and unmodified lee size die, you must size nose first. Just snap the check on and it will work fine.
"Is all this REALLY necessary?"
I have checks pull back in Lee dies when sized nose first. Some have had lube get under the check.
You can't do it base first with that boolit unless you have a base punch to fit the nose so you need to go nose first.
Won't hurt anything anyway.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |