just got an rcbs mold its the .30-180-fn read the instructions &it does not say anything about lubrication on the sprue cutter .Will the powder graphite that i use on my lyman mold be ok? I also have permatex anti-seize i use on lee molds.Lee says to use anti-seize lyman uses dry graphite.Thinkin its a steel mold so use the graphite.Thanks for any help Bob
Shop[/url]
Last edited by Three-Fifty-Seven; 06-20-2020 at 11:12 AM.
John 3: 16 For God so loved the world, that he gave his only begotten Son, that whosoever believeth in him should not perish, but have everlasting life.
Bull Plate lube available from BullShop, a member here, applied very sparingly
works extremely well. It will remove existing lead smears over a casting session
and prevents new lead smears. Also good on mold alignment features.
Bill
If it was easy, anybody could do it.
thanks guys gonna look into bullplate .I have seen bullplate spoken of often on this site so it must be good stuff gonna try it thanks again.I really like this site
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote