RotoMetals2Load DataSnyders JerkyMidSouth Shooters Supply
Lee PrecisionWidenersReloading EverythingTitan Reloading
Inline Fabrication Repackbox
Results 1 to 2 of 2

Thread: Tang sight & tang safety..an issue?

  1. 10-03-2007, 10:11 PM #1
    guninhand
    guninhand is offline
    Boolit Buddy guninhand's Avatar
    Join Date
    Feb 2006
    Posts
    229

    Tang sight & tang safety..an issue?

    I'm thinking of putting a Marbles tang sight, made for a gun with a tang safety, on my Mikoru 1892 Winchester. Who has tried this set up and were there any problems? Did the tang need any extra holes drilled and tapped? TIA
    Reply With Quote Reply With Quote
  2. 10-04-2007, 01:16 AM #2
    Jon K
    Jon K is offline
    Boolit Master
    Jon K's Avatar
    Join Date
    Mar 2006
    Location
    CA
    Posts
    1,756
    guninhand,

    Good question, mine is a pre-safety, and holes had to be drilled and tapped.

    Call them, they are very good people, and they will answer whatever questions for you.
    Address
    Marble's
    420 Industrial Park
    Gladstone, MI 49837

    Phone
    906-428-3710

    Jon
    Col 2:13-17
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check