"Hammer Mold"?

[Whitespider]

I just created a login for the Group Buy section. I wanted to check it out because I’m sure I’ll be using it, this stuff is addicting. I looked around figured most of it out real quick.

But I don’t get the “hammer mold” section, what’s that all about? What’s a “hammer mold”?

Thanks

[45nut]

have a look in the benefit auctions inside the swapping and selling forum.

[Whitespider]

Thanks 45nut

Ooooohhhh man, I can’t believe I couldn’t figure out what a HAMMER is. I know y’all can’t see it but I’ve turned “red faced” right now.

[Springfield]

I received the groups hammer mould today, and spent most of the evening making me 11 new hammers. Actually I replaced the head on my old lead hammer, made 2 new hammers and 8 spare heads for later on. I don't know how you guys are going to do it, but I just used some 1/2" pipe with a cap on the end. Fits the mold real nice. After I cast the head I unscrew the pipe, leaving the cap inside, and make another one. So I have 8 replaceable heads for my 2 hammers. I had a little trouble keeping the lead inside the mould using a clamp on the bottom so I just clamped the head of the mould with a c-clamp. Seemed to make a better seal. So I'll be sending the mould on its way tomorrow. Off to Mr. Brown in Illinois.

[2 dogs]

I plan to graft wings onto mine.....I will then have a "flying lead hammer" so lookout!

I know whitespider from another forum, he's great folks guys!

[Whitespider]

Thanks 2 dogs.

[Mohillbilly]

I too have good things to say for whitespider.A very good fellow.......he is kind ,knowlageable, and generous........

[Whitespider]

Thanks Mohillbilly

You guys are makin' my face turn red again!