I just sold a certified golden oldie, I've had an old single cavity LEE mould that was held together with screws? Remember those? Flathead, slotted screws holding the handles and the sprue plate. I clean forgot that they used to make them that way....
Bob
I bought one this spring with little or no use that is a copy of an old Ly design 235 gr 452 wadcutter. I haven't shot any yet and single cavity is a pain to cast but they look fine. When did they change to pins? I only started casting in 1987. Gianni.
[The Montana Gianni] Front sight and squeeze
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote