Thanks for the tip concerning the penta pins, tcbnick. They seem to not want to drop the bullets easily in several of my Mihec moulds.
Don
Thanks for the tip concerning the penta pins, tcbnick. They seem to not want to drop the bullets easily in several of my Mihec moulds.
Don
Another thing with the penta pins is the sides are not quite flat. They are slightly hollow ground. I dress mine on a fine diamond hone. It seems to relieve the "pinching" at the corners.
Guys,
Anyone cast some solids and weigh them to get a comparison with the hollow points yet?
Thanks,
Mike
My pleasure. Alot of guys seem to have soom trouble, just use a soft touch, cast a few and pay atttintion to the end of the boolit you can see where the problem is.
Last edited by thegreatdane; 01-11-2012 at 07:26 PM. Reason: typo!
scrap, smelt, cast, lube, load, shoot. repeat.
Aluminum range scrap?? ;o)
Dane, I figured, but didn't want to miss an opportunity. All in fun.
By the by, I just started with range scrap. Seems fine. What are you getting for BHN?
Hi what overall length do you set the bullet for the 45 acp
Regards Torben from Denmark
Anyone want to trade some bullets from this mold for some cleaned WW alloy? Looking for maybe 200 or so. 25-1 alloy
Mike
For the record, a dipper or pressure pouring works best for this mold. I had been using a bottom pour, and it left an irregular void on the HP pin. Using a dipper to simulate injection molding works amazing! Flawless HPs!
scrap, smelt, cast, lube, load, shoot. repeat.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |