Holy Kow!!! This thing is kicking my keyster all over the garage!! What I got: New Magma Star Lube-sizer, Magma lube heater(heater seems set correctly; not too stiff or too runny) LatheSmith die .431 with matching punch, Carnuba Red Lube, sizing Accurate Molds #43-240T.
Melted lube from stick in old four cup coffee maker poured into reservoir. Plug extra holes in die, (still plugged) and adjusted the punch and locked the lock ring on punch to correct depth with bullet nose first to line up lube grove with remaining open lube holes sized a previous sized bullet to lube die. Got couple partial fills re ran them through die. Ran 25 bullets through trying to figure out if there was point where it would settled down. Got partial fills, got fills with ogive covered in lube, got crimp groove filled with lube. I pulled die out to check and see if the plug holes came unplugged, When I pulled the die I had alot of lube come out which led me to believe too much pressure? Summed up I have got a mess reviled only to tumble lubing with uncut mule snot. Surprised there isn't a sticky already of troubleshooting procedures on these crazy things. I can't tell if I got too much pressure or not enough. I am pretty sure I got the depth right, but lubed crimp groove and ogive kind of suggests otherwise. The included instructions lol